PSU Watch logo

| IRCON emerges as the lowest bidder in NHAI & Chennai Metro projects |   | Govt aiming for 10% reduction in India’s crude oil import by next year: PNGRB Secretary |   | Mahanagar Gas Ltd hikes gas prices for 3rd time in six weeks |   | India to allow international flight operations from Dec 15 |   | RBI accepts 21 recommendations on ownership of private banks |  

Employees of the RSP bring substantial savings

The employees of structural and fabrication shop of RSP have successfully fabricated a scrap box of 32 tons capacity for Steel Melting Shop, using in-house resources and expertise
Rourkela: An enterprising endeavour of the structural and fabrication shop collective of SAIL's Rourkela Steel Plant (RSP) has brought substantial savings for the company. The department has successfully fabricated a scrap charging box of 32 tons capacity for Steel Melting Shop – II (SMS-II) department using in-house resources and expertise. Notably, the purchase of a new scrap box would have cost the company around Rs 40 lakhs. The 9 meter long, 3meter wide, 3 meter high and weighing about 30 tons, the scrap boxes are used for collecting scrap from the scrap yard, thereafter transporting and charging of scrap into the LD converters of SMS-II department. Notably, the existing scrap charging boxes were getting damaged and needing frequent repairs due to prolonged use. There was an urgent requirement to replace two such boxes. The structural and fabrication shop team under the guidance of General Manager (Structural & Fabrication Shop) SC Sabat took up the challenge to develop the scrap boxes using in-house resources as a cost-saving project. The detailed methodology for fabrication of the large 32-ton capacity box was chalked out and fabrication of the first box was completed successfully using in-house resources and expertise. The job consisted of developing and assembling half-cylindrical shell, brackets, trunion pins, tilting pin, liner plates and concrete box as the counterweight. All the activities like cutting of plates, bending, fabrication and machining were done in-house. Machining of the pins and bracket plates was done by the Mechanical Shop department. The job was completed in the shortest possible time of 3 months. The effort has not only boosted the morale of the team but also enhanced the equipment availability in SMS-II. Disclaimer: This story is a press release and is being published without any editing by PSU Watch desk. Our editorial team has only changed the headline.